Product Description

Aluminum Roof Roll Forming Machine

We have a factory,exporting Aluminum Roof Roll Forming Machine .There are three kinds of roll forming machine namely Corrugated Cold Roll Forming Machine,

Glazed Tile Cold Roll Forming Machine, Trapezoid Steel Sheet Roll Forming Machine .The machine consists of manual decoiler or Hydraulic Decoiler,

PLC control cabinet ,hydraulic cutting,product rack,roll forming station,hydraulic motor.

Specifications:

Roll Forming Machine Feeding material: zinc-coated steel coil

Cold Roll Forming Machine Thickness of the plate:0.3-0.8mm

Feeding Material width:1000/1200/1250mm

Machine size: (depend on design)

Diameter of the axle :Φ70mm-Φ90mm

Rolling material: 45# steel with hard chrome plated

Rolling station:14-20 rows of rollers

Productivity:10-12m/min

Voltage:380V 60Hz 3phase or as requirement

Base frame:300/350mm H-beam steel

Side board thickness:16mm

Cutting blade: Cr12 with heat treatment

Cutting system: Hydraulic cutting system after forming

Control cabinet: PLC and frequency changer in it

Warranty:12 months limited warranty

Delivery: 30 days after receipt of advance payment

Package: Plastic packing and nude in the container

Payment Term: T/T, L/C, Trade assurance

Produce process flow

Components

1.Manual un-coiler:to load steel coils

2. Roll-forming M/C: Roller Mareial: 45# steel with hard chrome

3. Hydraulic systerm

It is controlled by gear wheel oil pump. After filling the hydraulic oil into the hydraulic oil tank ,the pump drive the cutter machine to begin the cutting job. Match equipment: a set of hydraulic tank , a set of hydraulic oil pump, two hydraulic pipes and two sets of electromagnetism valves.

4.Computer control cabinet

It adopts Taida PLC to control(can make as your requirement). The target piece length is adjustable and digit of it can be adjusted.

Computed mode has two modes: automatic and manual one.

5. Cutting Mechanism

It adopts hydraulic drive and automatic location to decide the dimention and cut the target products.

Match equipment : one set of cutting tool, one hydraulic tank ,one cutter machine. Stop to cut , Post cut

6. Recieving table:Main framework adopts welded steel and supported roller, and used for transmit and collect the finished products.

Packing&shippment

1.Packing:the main parts will be packed with plastic film then fixed to container by iron wire

2.Shippin:shipped in 30days after receiving the full deposit

Contact us if you need more details on Corrugated Cold Roll Forming Machine. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Glazed Tile Cold Roll Forming Machine、Trapezoid Steel Sheet Roll Forming Machine. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Roll Forming Machine > Single Layer Roof Roll Forming Machine